comparison man/mark.texi @ 38482:c8c4805bde95

Minor changes from Richard Stallman.

38481:33c054df8f9f

@kindex C-x C-x
@findex exchange-point-and-mark
  Ordinary terminals have only one cursor, so there is no way for Emacs
to show you where the mark is located.  You have to remember.  The usual
solution to this problem is to set the mark and then use it before
you forget where it is.  Alternatively, you can see where the mark is
with the command @kbd{C-x C-x} (@code{exchange-point-and-mark}) which
puts the mark where point was and point where the mark was.  The extent
of the region is unchanged, but the cursor and point are now at the
previous position of the mark.  In Transient Mark mode, this command

deactivates the mark.  This means any subsequent command that operates
on a region will get an error and refuse to operate.  You can make the
region active again by typing @kbd{C-x C-x}.

@item
Commands like @kbd{M->} and @kbd{C-s} that ``leave the mark behind'', in
addition to some other primary purpose, do not activate the new mark.
You can activate the new region by executing @kbd{C-x C-x}
(@code{exchange-point-and-mark}).

@item

Print hardcopy with @kbd{M-x print-region} (@pxref{Hardcopy}).
@item
Evaluate it as Lisp code with @kbd{M-x eval-region} (@pxref{Lisp Eval}).
@end itemize

  Most commands that operate on text in the region have the word
@code{region} in their names.

@node Marking Objects
@section Commands to Mark Textual Objects

38482:c8c4805bde95

@kindex C-x C-x
@findex exchange-point-and-mark
  Ordinary terminals have only one cursor, so there is no way for Emacs
to show you where the mark is located.  You have to remember.  The usual
solution to this problem is to set the mark and then use it soon, before
you forget where it is.  Alternatively, you can see where the mark is
with the command @kbd{C-x C-x} (@code{exchange-point-and-mark}) which
puts the mark where point was and point where the mark was.  The extent
of the region is unchanged, but the cursor and point are now at the
previous position of the mark.  In Transient Mark mode, this command

deactivates the mark.  This means any subsequent command that operates
on a region will get an error and refuse to operate.  You can make the
region active again by typing @kbd{C-x C-x}.

@item
Commands like @kbd{M->} and @kbd{C-s} that ``leave the mark behind'' in
addition to some other primary purpose, do not activate the new mark.
You can activate the new region by executing @kbd{C-x C-x}
(@code{exchange-point-and-mark}).

@item

Print hardcopy with @kbd{M-x print-region} (@pxref{Hardcopy}).
@item
Evaluate it as Lisp code with @kbd{M-x eval-region} (@pxref{Lisp Eval}).
@end itemize

  Most commands that operate on the text in the region have the word
@code{region} in their names.

@node Marking Objects
@section Commands to Mark Textual Objects