Mercurial > emacs
view etc/3B-MAXMEM @ 27636:161ec77aa308
(font-lock-keywords): Fix doc for multiline matches.
(font-lock-add-keywords): Make it work even if font-lock-mode is nil,
so that it can be used more easily in <foo>-mode-hook. Also make sure
to avoid duplicate entries.
(font-lock-update-removed-keyword-alist): Renamed `major-mode'->`mode'.
(font-lock-remove-keywords): Just as was done for `add', allow it to
work even if font-lock-mode is nil. Also make sure we don't modify
any pre-existing list by forcing a copy-sequence. Finally rename
`major-mode' to `mode'.
(font-lock-fontify-syntactic-anchored-keywords)
(font-lock-fontify-anchored-keywords)
(font-lock-fontify-keywords-region): Use line-end-position.
Don't make `font-lock-multiline' local (it's now done in
font-lock-set-defaults).
(font-lock-set-defaults): Make `font-lock-multiline' local. Also
move the `font-lock-fontified' creation to inside the `unless'.
author | Stefan Monnier <monnier@iro.umontreal.ca> |
---|---|
date | Mon, 07 Feb 2000 01:49:33 +0000 |
parents | e96ffe544684 |
children |
line wrap: on
line source
Date: Mon, 16 Feb 87 15:04:41 EST From: katinsky@gauss.rutgers.edu (David Katinsky) To: rms@prep.ai.mit.edu Subject: 3b2 procedure to raise MAXMEM Below is the procedure I followed to allow enough memory for GnuEmacs to run on my 3b2/400. The end result of this is that a process can snarf up to 2Mb of memory. This can be a bit dangerous on a 2Mb machine, but I tried it and it worked ok. ------------------------------------------------------------------------------- In the simplest case, these are the procedures to reconfigure a 3bx kernel. 1] cd /etc/master.d `ls` shows the files to be: README ctc* hdelog idisk ipc iuart kernel mau mem msg ports* prf sem shm stubs sxt sys xt 2] Edit the file which contains the parameter[s] you wish to change. In the following excerpt from /etc/master.d/kernel the value MAXMEM was raised from 256 to 1024. In V.3.0 and later releases, the parameter in question is MAXUMEM instead of MAXMEM. * * The following entries form the tunable parameter table. * NCALL = 30 NPROC = 60 NTEXT = 58 NCLIST = 188 * maxmem is number of pages (2K) was 256 --dmk MAXMEM = 1024 MAXUP = 25 * hashbuf must be a power of 2 NHBUF = 128 NPBUF = 8 3] cd /boot 4] mkboot -k KERNEL 5] shutdown -i5 -g0 -y This will take the machine down and bring it back up into firmware mode. When you see that the machine has reached this state, type the firmware password (default=mcp). The machine will ask for the name of a program to execute. At this prompt enter /etc/system . The machine should start to boot and display its configuration data. 8701271222 dmk [katinsky@topaz.rutgers.edu] ------------------------------------------------------------------------------- I do not feel that having the default firmware password is a problem... but if you wish to edit it out, feel free. dmk