view src/s/irix6-0.h @ 48659:4d69c0f01cc0

(gdb-inferior-io-mode-map): Remove (unused). (gdb-inferior-io-mode): Use define-minor-mode. (gdb-source-info): Don't burp if there's no source file. (gdb-inferior-io-interrupt, gdb-inferior-io-quit) (gdb-inferior-io-stop, gdb-inferior-io-eof) (gdb-display-breakpoints-buffer, gdb-frame-breakpoints-buffer) (gdb-display-stack-buffer, gdb-frame-stack-buffer) (gdb-display-registers-buffer, gdb-frame-registers-buffer) (gdb-display-locals-buffer, gdb-frame-locals-buffer) (gdb-display-display-buffer, gdb-frame-display-buffer) (gdb-display-gdb-buffer, gdb-frame-gdb-buffer) (gdb-display-assembler-buffer, gdb-frame-assembler-buffer): Remove the spurious left over arg from the "big reorg".

#include "irix5-0.h"

/* Irix 6 tries to do 64 bits, but doesn't do it fully,
   so inhibit that.  */
#define IRIX_FORCE_32_BITS

#ifndef __GNUC__
#define LD_SWITCH_SYSTEM -32
#endif

/* This macro definition, which we inherited from irix5-0.h,
   is needed in configure on Irix 5, but gets in the way there
   on Irix 6.  So get rid of it except in Makefile.in where we need it.  */
#ifndef THIS_IS_MAKEFILE
#undef C_SWITCH_SYSTEM
#endif

/* The only supported 32-bit configuration of GCC under IRIX6.x produces
   n32 MIPS ABI binaries and also supports -g. */
#ifdef __GNUC__
#undef C_DEBUG_SWITCH
#define C_DEBUG_SWITCH -g
#endif

#undef SA_RESTART

/* It turns out that the #define in irix5-0.h is needed in Irix 6 as well.  */
#if 0
/* Cancel the #define that is in irix5-0.h.  */
#undef ospeed
#endif

#undef TIOCSIGSEND

/* Tested on Irix 6.5.  SCM worked on earlier versions.  */
#define GC_SETJMP_WORKS 1
#define GC_MARK_STACK GC_MAKE_GCPROS_NOOPS