Mercurial > emacs
view etc/3B-MAXMEM @ 26836:7c90254477b0
(INTERVAL_SRC): Include composite.h.
(INTERVAL_OBJ): Include composite.o.
(SOME_MACHINE_OBJECTS): Include composite.o.
(casefiddle.o) (dispnew.o) (indent.o) (process.o) (search.o)
(syntax.o) (window.o) (xdisp.o) (xfaces.o) (xterm.o) (print.o):
Depend on composite.h.
(doc.o): Depend on charset.h.
(keyboard.o) (textprop.o) (intervals.o): Depend on INTERVAL_SRC.
(composite.o): New target.
author | Kenichi Handa <handa@m17n.org> |
---|---|
date | Wed, 15 Dec 1999 00:01:14 +0000 |
parents | e96ffe544684 |
children |
line wrap: on
line source
Date: Mon, 16 Feb 87 15:04:41 EST From: katinsky@gauss.rutgers.edu (David Katinsky) To: rms@prep.ai.mit.edu Subject: 3b2 procedure to raise MAXMEM Below is the procedure I followed to allow enough memory for GnuEmacs to run on my 3b2/400. The end result of this is that a process can snarf up to 2Mb of memory. This can be a bit dangerous on a 2Mb machine, but I tried it and it worked ok. ------------------------------------------------------------------------------- In the simplest case, these are the procedures to reconfigure a 3bx kernel. 1] cd /etc/master.d `ls` shows the files to be: README ctc* hdelog idisk ipc iuart kernel mau mem msg ports* prf sem shm stubs sxt sys xt 2] Edit the file which contains the parameter[s] you wish to change. In the following excerpt from /etc/master.d/kernel the value MAXMEM was raised from 256 to 1024. In V.3.0 and later releases, the parameter in question is MAXUMEM instead of MAXMEM. * * The following entries form the tunable parameter table. * NCALL = 30 NPROC = 60 NTEXT = 58 NCLIST = 188 * maxmem is number of pages (2K) was 256 --dmk MAXMEM = 1024 MAXUP = 25 * hashbuf must be a power of 2 NHBUF = 128 NPBUF = 8 3] cd /boot 4] mkboot -k KERNEL 5] shutdown -i5 -g0 -y This will take the machine down and bring it back up into firmware mode. When you see that the machine has reached this state, type the firmware password (default=mcp). The machine will ask for the name of a program to execute. At this prompt enter /etc/system . The machine should start to boot and display its configuration data. 8701271222 dmk [katinsky@topaz.rutgers.edu] ------------------------------------------------------------------------------- I do not feel that having the default firmware password is a problem... but if you wish to edit it out, feel free. dmk