Mercurial > emacs
view etc/3B-MAXMEM @ 32216:82e4865603dd
(font-lock-defaults-alist): Remove the TeX entries.
(tex-font-lock-keywords, tex-font-lock-keywords-2)
(tex-font-lock-keywords-1): Remove.
(font-lock-turn-on-thing-lock): Use jit-lock-register.
(font-lock-turn-off-thing-lock): Use jit-lock-unregister.
(font-lock-default-fontify-region): Expand beg..end correctly
when just following a multiline region.
(font-lock-fontify-anchored-keywords):
Include the anchor text as part of the multiline.
author | Stefan Monnier <monnier@iro.umontreal.ca> |
---|---|
date | Fri, 06 Oct 2000 16:02:27 +0000 |
parents | e96ffe544684 |
children |
line wrap: on
line source
Date: Mon, 16 Feb 87 15:04:41 EST From: katinsky@gauss.rutgers.edu (David Katinsky) To: rms@prep.ai.mit.edu Subject: 3b2 procedure to raise MAXMEM Below is the procedure I followed to allow enough memory for GnuEmacs to run on my 3b2/400. The end result of this is that a process can snarf up to 2Mb of memory. This can be a bit dangerous on a 2Mb machine, but I tried it and it worked ok. ------------------------------------------------------------------------------- In the simplest case, these are the procedures to reconfigure a 3bx kernel. 1] cd /etc/master.d `ls` shows the files to be: README ctc* hdelog idisk ipc iuart kernel mau mem msg ports* prf sem shm stubs sxt sys xt 2] Edit the file which contains the parameter[s] you wish to change. In the following excerpt from /etc/master.d/kernel the value MAXMEM was raised from 256 to 1024. In V.3.0 and later releases, the parameter in question is MAXUMEM instead of MAXMEM. * * The following entries form the tunable parameter table. * NCALL = 30 NPROC = 60 NTEXT = 58 NCLIST = 188 * maxmem is number of pages (2K) was 256 --dmk MAXMEM = 1024 MAXUP = 25 * hashbuf must be a power of 2 NHBUF = 128 NPBUF = 8 3] cd /boot 4] mkboot -k KERNEL 5] shutdown -i5 -g0 -y This will take the machine down and bring it back up into firmware mode. When you see that the machine has reached this state, type the firmware password (default=mcp). The machine will ask for the name of a program to execute. At this prompt enter /etc/system . The machine should start to boot and display its configuration data. 8701271222 dmk [katinsky@topaz.rutgers.edu] ------------------------------------------------------------------------------- I do not feel that having the default firmware password is a problem... but if you wish to edit it out, feel free. dmk