view etc/3B-MAXMEM @ 28904:8d91ded5215c

(comment-start, comment-start-skip, comment-end): Made `defvar'. (comment-style): Extract the choice out of comment-styles. (comment-continue): Just a simple string now. (comment-normalize-vars): Update for the new comment-continue. (until, comment-end-quote-re): Removed. (comment-quote-re, comment-quote-nested): New functions for quoting. These quote both the end and the start and also work for single-chars. (comment-padright): Added lots of comments. (comment-padleft): Added more comments. Check comment-end rather than STR to determine whether N can be applied or not. (uncomment-region): Rename BLOCK to BOX. Use the new comment-quote-nested. Use only one marker and properly set it back to nil. Be more picky when eliminating continuation markers.

Date: Mon, 16 Feb 87 15:04:41 EST
From: [e-mail] (David Katinsky)
To: [e-mail]
Subject: 3b2 procedure to raise MAXMEM

Below is the procedure I followed to allow enough memory for GnuEmacs to run
on my 3b2/400. The end result of this is that a process can snarf up to 2Mb
of memory. This can be a bit dangerous on a 2Mb machine, but I tried it and 
it worked ok.

-------------------------------------------------------------------------------

In the simplest case, these are the procedures to reconfigure a 3bx kernel.



1] cd /etc/master.d

`ls` shows the files to be:

README   ctc*     hdelog   idisk    ipc      iuart    kernel   mau
mem      msg      ports*   prf      sem      shm      stubs    sxt
sys      xt

2] Edit the file which contains the parameter[s] you wish to change.
In the following excerpt from /etc/master.d/kernel the value MAXMEM
was raised from 256 to 1024.

In V.3.0 and later releases, the parameter in question is MAXUMEM
instead of MAXMEM.


	*
	* The following entries form the tunable parameter table.
	*


	NCALL = 30
	NPROC = 60
	NTEXT = 58
	NCLIST = 188
	* maxmem is number of pages (2K) was 256 --dmk
	MAXMEM = 1024
	MAXUP = 25
	* hashbuf must be a power of 2
	NHBUF = 128
	NPBUF = 8

3] cd /boot

4] mkboot -k KERNEL

5] shutdown -i5 -g0 -y

This will take the machine down and bring it back up into firmware
mode. When you see that the machine has reached this state, type the
firmware password (default=mcp). The machine will ask for the name of
a program to execute. At this prompt enter /etc/system . The machine
should start to boot and display its configuration data.



8701271222					dmk

						[[e-mail]]
-------------------------------------------------------------------------------



I do not feel that having the default firmware password is a
problem... but if you wish to edit it out, feel free.

						dmk