view src/s/irix6-0.h @ 49371:c73ce11bb264

2003-01-21 KOBAYASHI Yasuhiro <[e-mail]> * w32term.c (note_mode_line_highlight): Delete #if 0 to enable function w32_define_cursor. (note_mouse_highlight): Initialize, setup cursor accoding to mouse position, change member name output_data.x to output_data.w32 and add function w32_define_cursor. (show_mouse_face): Delete #if 0 to enable function w32_define_cursor and change member name output_data.x to output_data.w32. (w32_initialize_display_info): Setup dpyinfo->vertical_scroll_bar_cursor. 2003-01-21 David Ponce <[e-mail]> * w32term.c (w32_encode_char): For DIM=1 charset, set ccl->reg[2] to -1 before calling ccl_driver. (Sync. with xterm.c x_encode_char change by Kenichi Handa <[e-mail]> on 2002-09-30. (w32_draw_relief_rect): Declare all args. (w32_define_cursor): New.

#include "irix5-0.h"

/* Irix 6 tries to do 64 bits, but doesn't do it fully,
   so inhibit that.  */
#define IRIX_FORCE_32_BITS

#ifndef __GNUC__
#define LD_SWITCH_SYSTEM -32
#endif

/* This macro definition, which we inherited from irix5-0.h,
   is needed in configure on Irix 5, but gets in the way there
   on Irix 6.  So get rid of it except in Makefile.in where we need it.  */
#ifndef THIS_IS_MAKEFILE
#undef C_SWITCH_SYSTEM
#endif

/* The only supported 32-bit configuration of GCC under IRIX6.x produces
   n32 MIPS ABI binaries and also supports -g. */
#ifdef __GNUC__
#undef C_DEBUG_SWITCH
#define C_DEBUG_SWITCH -g
#endif

#undef SA_RESTART

/* It turns out that the #define in irix5-0.h is needed in Irix 6 as well.  */
#if 0
/* Cancel the #define that is in irix5-0.h.  */
#undef ospeed
#endif

#undef TIOCSIGSEND

/* Tested on Irix 6.5.  SCM worked on earlier versions.  */
#define GC_SETJMP_WORKS 1
#define GC_MARK_STACK GC_MAKE_GCPROS_NOOPS