view src/s/irix6-0.h @ 51321:e005bbe7be9e

(edebug-window-list): Use push. (edebug-macrop): Use functionp. (edebug-functionp): Remove. (edebug-get-displayed-buffer-points): Use push. (edebug-set-buffer-points): Use save-current-buffer and buffer-live-p. (edebug-list-form): Remove dead code. (backquote-form): Correctly handle `(a . ,b). (edebug-mode-map, global-edebug-map): Move init to inside the defvar.

#include "irix5-0.h"

/* Irix 6 tries to do 64 bits, but doesn't do it fully,
   so inhibit that.  */
#define IRIX_FORCE_32_BITS

#ifndef __GNUC__
#define LD_SWITCH_SYSTEM -32
#endif

/* This macro definition, which we inherited from irix5-0.h,
   is needed in configure on Irix 5, but gets in the way there
   on Irix 6.  So get rid of it except in Makefile.in where we need it.  */
#ifndef THIS_IS_MAKEFILE
#undef C_SWITCH_SYSTEM
#endif

/* The only supported 32-bit configuration of GCC under IRIX6.x produces
   n32 MIPS ABI binaries and also supports -g. */
#ifdef __GNUC__
#undef C_DEBUG_SWITCH
#define C_DEBUG_SWITCH -g
#endif

#undef SA_RESTART

/* It turns out that the #define in irix5-0.h is needed in Irix 6 as well.  */
#if 0
/* Cancel the #define that is in irix5-0.h.  */
#undef ospeed
#endif

#undef TIOCSIGSEND

/* Tested on Irix 6.5.  SCM worked on earlier versions.  */
#define GC_SETJMP_WORKS 1
#define GC_MARK_STACK GC_MAKE_GCPROS_NOOPS