changeset 33744:67204e92850a

Tweak non-ASCII display.

--- a/man/display.texi	Wed Nov 22 12:59:03 2000 +0000
+++ b/man/display.texi	Wed Nov 22 13:55:24 2000 +0000
@@ -324,12 +324,15 @@
 (@samp{^}) followed by the non-control version of the character; thus,
 control-A is displayed as @samp{^A}.
 
-  Non-ASCII characters 0200 through 0377 are displayed with octal escape
-sequences; thus, character code 0243 (octal) is displayed as
-@samp{\243}.  However, if you enable European display, most of these
-characters become non-ASCII printing characters, and are displayed using
-their graphics (assuming your terminal supports them).
-@xref{Single-Byte Character Support}.
+  Non-ASCII characters 0200 through 0237 (octal) are displayed with
+octal escape sequences; thus, character code 0230 (octal) is displayed
+as @samp{\230}.  The display of character codes 0240 through 0377
+(octal) may be either as escape sequences or as graphics.  They do not
+normally occur in multibyte buffers but if they do, they are displayed
+as Latin-1 graphics.  In unibyte mode, if you enable European display
+they are displayed using their graphics (assuming your terminal supports
+them), otherwise as escape sequences.  @xref{Single-Byte Character
+Support}.
 
 @node Display Vars
 @section Variables Controlling Display