view libfaad2/Makefile @ 18708:9e2b300db17b

Change free_sh_audio() to take demuxer and stream id as parameters (same as new_sh_audio()) instead of sh_audio_t *, use those to remove the pointer from demuxer->a_streams[] before freeing it. Some demuxers use free_sh_audio() to undo the creation of an already-allocated audio stream in case of error. These uses were unsafe since free_sh_audio() freed the data structure but left the pointer in demuxer->a_streams[], leading to double free later in free_demuxer() (and perhaps use of the freed stream before that, I didn't check).

LIBNAME = libfaad2.a

include ../config.mak

SRCS    = bits.c \
          cfft.c \
          common.c \
          decoder.c \
          drc.c \
          drm_dec.c \
          error.c \
          filtbank.c \
          hcr.c \
          huffman.c \
          ic_predict.c \
          is.c \
          lt_predict.c \
          mdct.c \
          mp4.c \
          ms.c \
          output.c \
          pns.c \
          ps_dec.c \
          ps_syntax.c  \
          pulse.c \
          rvlc.c \
          sbr_dct.c \
          sbr_dec.c \
          sbr_e_nf.c \
          sbr_fbt.c \
          sbr_hfadj.c \
          sbr_hfgen.c \
          sbr_huff.c \
          sbr_qmf.c \
          sbr_syntax.c \
          sbr_tf_grid.c \
          specrec.c \
          ssr.c \
          ssr_fb.c \
          ssr_ipqf.c \
          syntax.c \
          tns.c \

OBJS	= $(SRCS:.c=.o)

CFLAGS  = -I. $(OPTFLAGS) -D_GNU_SOURCE

# Uncomment this to use the FIXED_POINT implementation of FAAD2.
# This should improve performance, especially for SBR files.
#CFLAGS  = -I. $(OPTFLAGS) -DFIXED_POINT

.SUFFIXES: .c .o

# .PHONY: all clean

.c.o:
	$(CC) -c $(CFLAGS) -o $@ $<

$(LIBNAME):	$(OBJS)
	$(AR) r $(LIBNAME) $(OBJS)
	$(RANLIB) $(LIBNAME)

all:	$(LIBNAME)

clean:
	rm -f *.o *.a *~

distclean: clean
	rm -f .depend test

dep:    depend

depend:
	$(CC) -MM $(CFLAGS) $(SRCS) 1>.depend

#
# include dependency files if they exist
#
ifneq ($(wildcard .depend),)
include .depend
endif