view liba52/test.c @ 23572:a00685941686

demux_mkv very long seek fix The seek code searching for the closest position in the index used "int64_t min_diff=0xFFFFFFFL" as the initial "further from the goal than any real alternative" value. The unit is milliseconds so seeks more than about 75 hours past the end of the file would fail to recognize the last index position as the best match. This was triggered in practice by chapter seek code which apparently uses a seek of 1000000000 seconds forward to mean "seek to the end". The practical effect was that trying to seek to the next chapter in a file without chapters made MPlayer block until it finished reading the file from the current position to the end. Fixed by increasing the initial value from FFFFFFF to FFFFFFFFFFFFFFF.

// liba52 sample by A'rpi/ESP-team
// reads ac3 stream form stdin, decodes and downmix to s16 stereo pcm and
// writes it to stdout.  resulting stream playbackable with sox:
//   play -c 2 -r 48000 out.sw

//#define TIMING //needs Pentium or newer 

#include <stdio.h>
#include <stdlib.h>
#include <inttypes.h>
#include <string.h>

#include "a52.h"
#include "mm_accel.h"
#include "../cpudetect.h"

static sample_t * samples;
static a52_state_t state;
static uint8_t buf[3840];
static int buf_size=0;

static int16_t out_buf[6*256*6];

void mp_msg_c( int x, const char *format, ... ) // stub for cpudetect.c
{
}

#ifdef TIMING
static inline long long rdtsc()
{
	long long l;
	asm volatile(	"rdtsc\n\t"
		: "=A" (l)
	);
//	printf("%d\n", int(l/1000));
	return l;
}

#define STARTTIMING t=rdtsc();
#define ENDTIMING sum+=rdtsc()-t; t=rdtsc();
#else
#define STARTTIMING ;
#define ENDTIMING ;
#endif


int main(){
int accel=0;
int sample_rate=0;
int bit_rate=0;
#ifdef TIMING
long long t, sum=0, min=256*256*256*64;
#endif

    FILE *temp= stdout;
    stdout= stderr; //EVIL HACK FIXME
    GetCpuCaps(&gCpuCaps);
    stdout= temp;
//    gCpuCaps.hasMMX=0;
//    gCpuCaps.hasSSE=0;
    if(gCpuCaps.hasMMX) 	accel |= MM_ACCEL_X86_MMX;
    if(gCpuCaps.hasMMX2) 	accel |= MM_ACCEL_X86_MMXEXT;
    if(gCpuCaps.hasSSE) 	accel |= MM_ACCEL_X86_SSE;
    if(gCpuCaps.has3DNow) 	accel |= MM_ACCEL_X86_3DNOW;
//    if(gCpuCaps.has3DNowExt) 	accel |= MM_ACCEL_X86_3DNOWEXT;
    
    samples = a52_init (accel);
    if (samples == NULL) {
	fprintf (stderr, "A52 init failed\n");
	return 1;
    }

while(1){
    int length,i;
    int16_t *s16;
    sample_t level=1, bias=384;
    int flags=0;
    int channels=0;

    while(buf_size<7){
	int c=getchar();
	if(c<0) goto eof;
	buf[buf_size++]=c;
    }
STARTTIMING
    length = a52_syncinfo (buf, &flags, &sample_rate, &bit_rate);
ENDTIMING
    if(!length){
	// bad file => resync
	memcpy(buf,buf+1,6);
	--buf_size;
	continue;
    }
    fprintf(stderr,"sync. %d bytes  0x%X  %d Hz  %d kbit\n",length,flags,sample_rate,bit_rate);
    while(buf_size<length){
	buf[buf_size++]=getchar();
    }
    
    buf_size=0;

    // decode:
    flags=A52_STEREO; //A52_STEREO; //A52_DOLBY; //A52_STEREO; // A52_DOLBY // A52_2F2R // A52_3F2R | A52_LFE
    channels=2;
    
    flags |= A52_ADJUST_LEVEL;
STARTTIMING
    if (a52_frame (&state, buf, &flags, &level, bias))
	{ fprintf(stderr,"error at decoding\n"); continue; }
ENDTIMING

    // a52_dynrng (&state, NULL, NULL); // disable dynamic range compensation

STARTTIMING
    a52_resample_init(accel,flags,channels);
    s16 = out_buf;
    for (i = 0; i < 6; i++) {
	if (a52_block (&state, samples))
	    { fprintf(stderr,"error at sampling\n"); break; }
	// float->int + channels interleaving:
	s16+=a52_resample(samples,s16);
ENDTIMING
    }
#ifdef TIMING
if(sum<min) min=sum;
sum=0;
#endif
    fwrite(out_buf,6*256*2*channels,1,stdout);

}

eof:
#ifdef TIMING
fprintf(stderr, "%4.4fk cycles ",min/1000.0);
sum=0;
#endif
}