view osdep/fseeko.c @ 20902:bfb6eacd9c4a

Update OSD contents only after the correct values for the frame are known. The most visible inaccuracy caused by the previous update location was that the OSD always showed position 0 after seeking with demux_mkv. Split frame decoding and filtering because with -correct-pts the pts value that should be displayed for the frame is only known after decoding but is needed before filtering (during which the OSD is drawn).

/*
 * fseeko.c
 *	  64-bit versions of fseeko/ftello() for systems which do not have them
 */

#include "config.h"
 
#if !defined(HAVE_FSEEKO) || !defined(HAVE_FTELLO)
#include <stdio.h>
#include <sys/types.h>
#include <sys/stat.h>
#include <errno.h>
#endif

#ifdef WIN32
#define flockfile
#define funlockfile
#endif

/*
 *	On BSD/OS and NetBSD (and perhaps others), off_t and fpos_t are the 
 *      same.  Standards say off_t is an arithmetic type, but not necessarily 
 *      integral, while fpos_t might be neither.
 *
 *	This is thread-safe on BSD/OS using flockfile/funlockfile.
 */

#ifndef HAVE_FSEEKO
int
fseeko(FILE *stream, off_t offset, int whence)
{
	fpos_t floc;
	struct stat filestat;

	switch (whence)
	{
		case SEEK_CUR:
			flockfile(stream);
			if (fgetpos(stream, &floc) != 0)
				goto failure;
			floc += offset;
			if (fsetpos(stream, &floc) != 0)
				goto failure;
			funlockfile(stream);
			return 0;
			break;
		case SEEK_SET:
			if (fsetpos(stream, &offset) != 0)
				return -1;
			return 0;
			break;
		case SEEK_END:
			flockfile(stream);
			if (fstat(fileno(stream), &filestat) != 0)
				goto failure;
			floc = filestat.st_size;
			if (fsetpos(stream, &floc) != 0)
				goto failure;
			funlockfile(stream);
			return 0;
			break;
		default:
			errno =	EINVAL;
			return -1;
	}

failure:
	funlockfile(stream);
	return -1;
}
#endif


#ifndef HAVE_FTELLO
off_t
ftello(FILE *stream)
{
	fpos_t floc;

	if (fgetpos(stream, &floc) != 0)
		return -1;
	return floc;
}
#endif