view DOCS/tech/slave.txt @ 12334:eeddcef4fb08

"hard" frame duplication for mencoder. this finally makes it possible to generate valid mpeg output from avi's that have duplicate frames in them, or when using inverse telecine filters. to use it, put the "harddup" filter at the end of your filter chain.

SLAVE MODE PROTOCOL
-------------------

If the -slave option is given, playback is controlled by a line-based protocol.
Each line must contain one of the following commands:

seek <value> [<type>]
    Seek to some place in the movie.
        0 is a relative seek of +/- <value> seconds (default).
        1 is a seek to <value> % in the movie.
        2 is a seek to an absolute position of <value> seconds.

edl_mark
    ???

audio_delay <value>
    Adjust the audio delay of value seconds.

quit
    Quit MPlayer.

pause
    Pause/unpause the playback.

grab_frames
    ???

pt_step <value> [<force>]
    Go to next/previous entry in the playtree.

pt_up_step <value> [<force>]
    Like pt_step but it jumps to next/previous in the parent list.

alt_src_step <value>
    When more than one source is available it selects the next/previous one
    (only supported by ASX playlist).

sub_delay <value> [<abs>]
    Adjust the subtitles delay of +/- <value> seconds or set it to <value>
    seconds when abs is nonzero.

osd [<level>]
    Toggle OSD mode or set it to level when level >= 0.

osd_show_text <value>

volume <value>
    Increase/decrease volume.

use_master
    Switch volume control between master and PCM.

mute
    Mute/unmute sound output.

[contrast|gamma|brightness|hue|saturation] <-100 - 100> [<abs>]
    Set/Adjust video parameters.

frame_drop [<value>]
    Toggle/Set frame dropping mode.

sub_pos <value>
    Adjust subtitles position.

sub_alignment <value>
    Set subtitle alignment.

sub_visibility
    Toggle subtitle visibility.

get_sub_visibility
    Print out subtitle visibility (1 == on, 0 == off).

vobsub_lang
    Switch the subtitle language when using VOBSub subtitles.

get_percent_pos
    Print out the current position in the file, in integer percentage [0-100).

get_time_length
    Print out the length of the current file in seconds.

vo_fullscreen
    Switch to fullscreen mode.

get_vo_fullscreen
    Print out fullscreen status (1 == fullscreened, 0 == windowed).

vo_ontop
	Toggle stay-on-top. Supported by drivers which use X11, except SDL,
	as well as directx and gl2 under Windows.

panscan <value> [value2]
    ???

loadfile <file|url>
    Load the given file/url.

loadlist <file>
    Load the given playlist file.

change_rectangle <val1> <val2>
    Change the position of the rectangle filter rectangle.
       <val1>
           Must be one of the following:
               0 = width
               1 = height
               2 = x position
               3 = y position
       <val2>
           For values of 0 or 1 for <val1>:
               Integer amount to add/subtract from the width/height.
               Positive values add to width/height and negative values
               subtract from it.
           For values of 2 or 3 for <val1>:
               Relative integer amount by which to move the upper left corner
               of the rectangle. Positive values move the rectangle right/down
               and negative values move the rectangle left/up.

dvdnav <button>
    Press the given dvdnav button.
        1 up
	2 down
	3 left
	4 right
	5 menu
	6 select

dvdnav_event <value>
    ???

tv_step_channel <channel>
    Select next/previous tv channel.

tv_step_norm
    Change TV norm.

tv_step_chanlist
    Change channel list.

tv_set_channel <channel>
    Set the current TV channel.

tv_last_channel
    Set the current TV channel to the last one.

tv_set_freq <frequency in MHz>
    Set the tv tuner frequency.

tv_set_norm <norm>
    Set the tv tuner norm. PAL, SECAM, NTSC and so on..

tv_set_brightness <-100 - 100>
    Set tv tuner brightness.

tv_set_contrast <-100 -100>
    Set tv tuner contrast.

tv_set_hue <-100 - 100>
    Set tv tuner hue.

tv_set_saturation <-100 - 100>
    Set tv tuner saturation.

gui_[loadfile|loadsubtitle|about|play|stop|gui_playlist|gui_preferences|skinbrowser]
    GUI actions

forced_subs_only
    Display forced subtitles only.

dvb_set_channel <channel_number> <card_number>
    Set DVB channel.

screenshot
    Take a screenshot.


menu <value>
    ???

set_menu <value>
    ???

help
    ???

exit
    ???

hide
    ???

run <value>
    ???