# HG changeset patch
# User diego
# Date 1067778207 0
# Node ID 496ff2403aaca6cabc0d55693cca603b1f50e6ac
# Parent  7d120a00fcf709a51b1c9e96a48c8224313c253a
buglets and consistency improvements

diff -r 7d120a00fcf7 -r 496ff2403aac DOCS/xml/en/video.xml
--- a/DOCS/xml/en/video.xml	Sun Nov 02 12:58:52 2003 +0000
+++ b/DOCS/xml/en/video.xml	Sun Nov 02 13:03:27 2003 +0000
@@ -12,7 +12,7 @@
 </para>
 
 <para>
-Do a <command>/proc/mtrr</command>:
+Do a <command>cat /proc/mtrr</command>:
 <screen>
 <prompt>--($:~)--</prompt> cat /proc/mtrr
 reg00: base=0xe4000000 (3648MB), size=  16MB: write-combining, count=9
@@ -80,8 +80,8 @@
 
 <para>
 Not all CPUs support MTRRs. For example older K6-2's (around 266MHz,
-stepping 0) doesn't support MTRR, but stepping 12's do (<command>cat /proc/cpuinfo
-</command> to check it).
+stepping 0) doesn't support MTRR, but stepping 12's do
+(<command>cat /proc/cpuinfo</command> to check it).
 </para>
 </sect3>
 
@@ -92,8 +92,8 @@
 
 <para>
 Under XFree86 4.0.2 or newer, you can use your card's hardware YUV routines
-using the XVideo extension. This is what the option '<option>-vo
-xv</option>' uses. Also, this is driver supports adjusting
+using the XVideo extension. This is what the option
+'<option>-vo xv</option>' uses. Also, this driver supports adjusting
 brightness/contrast/hue/etc (unless you use the old, slow DirectShow DivX
 codec, which supports it everywhere), see the man page.
 </para>
@@ -2027,8 +2027,8 @@
 Extra occurrences of <option>-zrcrop</option> invoke <emphasis>cinerama</emphasis>
 mode, i.e. you can distribute the movie over several TV's or beamers to create a
 larger screen. Suppose you have two beamers. The left one is connected to your
-Buz at <systemitem>/dev/video1</systemitem> and the right one is connected to
-your DC10+ at <systemitem>/dev/video0</systemitem>. The movie has a resolution
+Buz at <filename>/dev/video1</filename> and the right one is connected to
+your DC10+ at <filename>/dev/video0</filename>. The movie has a resolution
 of 704x288. Suppose also that you want the right beamer in black and white and
 that the left beamer should have JPEG frames at quality 10, then you would
 issue the following command