Mercurial > mplayer.hg

--- a/libvo/fastmemcpy.h	Sun Apr 22 17:07:57 2001 +0000
+++ b/libvo/fastmemcpy.h	Sun Apr 22 19:25:47 2001 +0000
@@ -1,12 +1,46 @@
-
 #ifndef __MPLAYER_MEMCPY
 #define __MPLAYER_MEMCPY

 /*
  This part of code was taken by from Linux-2.4.3 and slightly modified
-for MMX2 instruction set. I have done it since linux uses page aligned
+for MMX2, SSE instruction set. I have done it since linux uses page aligned
 blocks but mplayer uses weakly ordered data and original sources can not
-speedup their. Only using prefetchnta and movntq together have effect!
+speedup them. Only using PREFETCHNTA and MOVNTQ together have effect!
+
+From IA-32 Intel Architecture Software Developer's Manual Volume 1,
+Order Number 245470:
+"10.4.6. Cacheability Control, Prefetch, and Memory Ordering Instructions"
+
+Data referenced by a program can be temporal (data will be used again) or
+non-temporal (data will be referenced once and not reused in the immediate
+future). To make efficient use of the processor's caches, it is generally
+desirable to cache temporal data and not cache non-temporal data. Overloading
+the processor's caches with non-temporal data is sometimes referred to as
+"polluting the caches".
+The non-temporal data is written to memory with Write-Combining semantics.
+
+The PREFETCHh instructions permits a program to load data into the processor
+at a suggested cache level, so that it is closer to the processors load and
+store unit when it is needed. If the data is already present in a level of
+the cache hierarchy that is closer to the processor, the PREFETCHh instruction
+will not result in any data movement.
+But we should you PREFETCHNTA: Non-temporal data fetch data into location
+close to the processor, minimizing cache pollution.
+
+The MOVNTQ (store quadword using non-temporal hint) instruction stores
+packed integer data from an MMX register to memory, using a non-temporal hint.
+The MOVNTPS (store packed single-precision floating-point values using
+non-temporal hint) instruction stores packed floating-point data from an
+XMM register to memory, using a non-temporal hint.
+
+The SFENCE (Store Fence) instruction controls write ordering by creating a
+fence for memory store operations. This instruction guarantees that the results
+of every store instruction that precedes the store fence in program order is
+globally visible before any store instruction that follows the fence. The
+SFENCE instruction provides an efficient way of ensuring ordering between
+procedures that produce weakly-ordered data and procedures that consume that
+data.
+
 If you have questions please contact with me: Nick Kurshev: nickols_k@mail.ru.
 */

@@ -15,6 +49,11 @@

 #if defined( HAVE_MMX2 ) || defined( HAVE_3DNOW )

+#undef HAVE_K6_2PLUS
+#if !defined( HAVE_MMX2) && defined( HAVE_3DNOW)
+#define HAVE_K6_2PLUS
+#endif
+
 /* for small memory blocks (<256 bytes) this version is faster */
 #define small_memcpy(to,from,n)\
 {\
@@ -29,12 +68,11 @@
 	void *p;
 	int i;

-
 #ifdef HAVE_SSE /* Only P3 (may be Cyrix3) */
 //        printf("fastmemcpy_pre(0x%X,0x%X,0x%X)\n",to,from,len);
         // Align dest to 16-byte boundary:
-        if((unsigned int)to&15){
-          int len2=16-((unsigned int)to&15);
+        if((unsigned long)to&15){
+          int len2=16-((unsigned long)to&15);
           if(len>len2){
             len-=len2;
             __asm__ __volatile__(
@@ -46,7 +84,6 @@
         }
 //        printf("fastmemcpy(0x%X,0x%X,0x%X)\n",to,from,len);
 #endif
-

         if(len >= 0x200) /* 512-byte blocks */
 	{
@@ -55,13 +92,13 @@
 	  len&=63;

 	__asm__ __volatile__ (
-#if defined( HAVE_3DNOW ) && !defined( HAVE_MMX2 )
+#ifdef HAVE_K6_2PLUS
 	        "prefetch (%0)\n"
 	        "prefetch 64(%0)\n"
 	        "prefetch 128(%0)\n"
         	"prefetch 192(%0)\n"
         	"prefetch 256(%0)\n"
-#else
+#else /* K7, P3, CyrixIII */
 		"prefetchnta (%0)\n"
 		"prefetchnta 64(%0)\n"
 		"prefetchnta 128(%0)\n"
@@ -78,15 +115,13 @@
            perform reading and writing to be multiple to a number of
            processor's decoders, but it's not always possible.
         */
+#ifdef HAVE_SSE /* Only P3 (may be Cyrix3) */
+	if(((unsigned long)from) & 15)
+	/* if SRC is misaligned */
 	for(; i>0; i--)
 	{
 		__asm__ __volatile__ (
-#if defined( HAVE_3DNOW ) && !defined( HAVE_MMX2 )
-        	"prefetch 320(%0)\n"
-#else
 		"prefetchnta 320(%0)\n"
-#endif
-#ifdef HAVE_SSE /* Only P3 (may be Cyrix3) */
 		"movups (%0), %%xmm0\n"
 		"movups 16(%0), %%xmm1\n"
 		"movntps %%xmm0, (%1)\n"
@@ -95,8 +130,42 @@
 		"movups 48(%0), %%xmm1\n"
 		"movntps %%xmm0, 32(%1)\n"
 		"movntps %%xmm1, 48(%1)\n"
-#else /* Only K7 (may be other) */
-#if defined( HAVE_3DNOW ) && !defined( HAVE_MMX2 )
+		:: "r" (from), "r" (to) : "memory");
+		from+=64;
+		to+=64;
+	}
+	else
+	/*
+	   Only if SRC is aligned on 16-byte boundary.
+	   It allows to use movaps instead of movups, which required data
+	   to be aligned or a general-protection exception (#GP) is generated.
+	*/
+	for(; i>0; i--)
+	{
+		__asm__ __volatile__ (
+		"prefetchnta 320(%0)\n"
+		"movaps (%0), %%xmm0\n"
+		"movaps 16(%0), %%xmm1\n"
+		"movntps %%xmm0, (%1)\n"
+		"movntps %%xmm1, 16(%1)\n"
+		"movaps 32(%0), %%xmm0\n"
+		"movaps 48(%0), %%xmm1\n"
+		"movntps %%xmm0, 32(%1)\n"
+		"movntps %%xmm1, 48(%1)\n"
+		:: "r" (from), "r" (to) : "memory");
+		from+=64;
+		to+=64;
+	}
+#else
+	for(; i>0; i--)
+	{
+		__asm__ __volatile__ (
+#ifdef HAVE_K6_2PLUS
+        	"prefetch 320(%0)\n"
+#else
+		"prefetchnta 320(%0)\n"
+#endif
+#ifdef HAVE_K6_2PLUS
         	"movq (%0), %%mm0\n"
         	"movq 8(%0), %%mm1\n"
         	"movq 16(%0), %%mm2\n"
@@ -113,7 +182,7 @@
         	"movq %%mm1, 40(%1)\n"
         	"movq %%mm2, 48(%1)\n"
         	"movq %%mm3, 56(%1)\n"
-#else
+#else /* K7 */
 		"movq (%0), %%mm0\n"
 		"movq 8(%0), %%mm1\n"
 		"movq 16(%0), %%mm2\n"
@@ -131,15 +200,23 @@
 		"movntq %%mm2, 48(%1)\n"
 		"movntq %%mm3, 56(%1)\n"
 #endif
-#endif
 		:: "r" (from), "r" (to) : "memory");
 		from+=64;
 		to+=64;
 	}
-#if defined( HAVE_3DNOW ) && !defined( HAVE_MMX2 )
+#endif /* Have SSE */
+#ifdef HAVE_K6_2PLUS
+                /* On K6 femms is fatser of emms.
+		   On K7 femms is directly mapped on emms. */
 		__asm__ __volatile__ ("femms":::"memory");
-#else
+#else /* K7, P3, CyrixIII */
+                /* since movntq is weakly-ordered, a "sfence"
+		 * is needed to become ordered again. */
+		__asm__ __volatile__ ("sfence":::"memory");
+#ifndef HAVE_SSE
+		/* enables to use FPU */
 		__asm__ __volatile__ ("emms":::"memory");
+#endif
 #endif
 	}
 	/*
@@ -149,7 +226,6 @@
 	return p;
 }
 #define memcpy(a,b,c) fast_memcpy(a,b,c)
-
 #undef small_memcpy

 #endif