annotate doc/certificate-signals.dox @ 24477:d70eb6304eae

Use separate variables to keep track of the timer and the watcher. I believe only one of these will be used at any given time, and so while there is no overlap in their usage we need to use different variables so that we can call either purple_input_remove or purple_timeout_remove depending on the usage. I don't think this matters with glib because purple_input_remove and purple_timeout_remove both call g_source_remove, but it could be an issue when using other event loops. There's also the problem in line 673 where we add the watcher, but then if the call to msn_soap_write_cb fails we add a timer using the same variable. That's still going to be a little buggy.

/** @page certificate-signals Certificate Signals

 @signals
  @signal certificate-stored
  @signal certificate-deleted
 @endsignals

 @see certificate.h

 <hr>

 @signaldef certificate-stored
  @signalproto
void (*certificate_stored)(PurpleCertificatePool *pool, const gchar *id, gpointer data);
  @endsignalproto
  @signaldesc
   Emitted when a pool stores a certificate. Connect to the pool instance.
  @param pool    Pool the certificate has been stored into
  @param id      Key the certificate was stored under
 @endsignaldef

 @signaldef certificate-deleted
  @signalproto
void (*certificate_deleted)(PurpleCertificatePool *pool, const gchar *id, gpointer data);
  @endsignalproto
  @signaldesc
   Emitted when a pool deletes a certificate. Connect to the pool instance.
  @param pool    Pool the certificate was deleted from
  @param id      Key that was deleted
 @endsignaldef

 */
// vim: syntax=c.doxygen tw=75 et