Mercurial > pidgin.yaz
view README.dbus @ 12060:f7d2f637ff03
[gaim-migrate @ 14355]
sadrul writes:
This patch shows the last-used status-message for an
account in the account-specific statusbox.
It also hides the entry-box when there's no message in
it after the timeout. It'll be possible to bring it
back up by clicking on the statusbox with patch #1345942
Since I think 1345942 is still being debating, there's no way to get the
message box back after it disappears (except switching statuses). But this
is CVS, and there's another patch pending, so...
committer: Tailor Script <tailor@pidgin.im>
author | Tim Ringenbach <marv@pidgin.im> |
---|---|
date | Sun, 13 Nov 2005 00:05:44 +0000 |
parents | 2eca9ed49469 |
children |
line wrap: on
line source
This file describes how to compile and run gaim with dbus support. Hopefully, most of the steps from point 3 will soon be automated. 1. Make sure you have the latest version (0.34) of the dbus library installed, including glib bindings. http://www.freedesktop.org/Software/dbus 2. Compile gaim ./configure --enable-dbus make make install 3. Configure your dbus instalation for gaim A. Find your dbus session configuration file, usually /etc/dbus-1/session.conf B. In that file, find the <servicedir> section. This section contains the directory that stores files describing services, usually /usr/share/dbus-1/services C. Copy src/dbus-gaim.service to that directory D. Edit the dbus-gaim.service file you've just copied, and replace the path in the "Exec=" line with the path to your gaim executable. 4. Start Session DBUS if you haven't done it already eval `dbus-launch --session` export DBUS_SESSION_BUS_ADDRESS DBUS_SESSION_BUS_PID These commands will set the two above shell variables. These variables must be set before running any dbus-aware programs. Start gaim as usual. To communicate with it, use "gaim-send". When you execute gaim-send, the dbus system will automatically start a gaim process if one is not running already.