Mercurial > pidgin
view README.dbus @ 15986:0315b014741b
Check if debug_win is != NULL before checking the preference. This
should avoid a hash table lookup when debugging is turned off. I think
debug_win will ALWAYS be non-null when debugging is on and ALWAYS be
null when debugging is off, but I'm not positive and I didn't want
to break anything, so I left both checks in there.
author | Mark Doliner <mark@kingant.net> |
---|---|
date | Tue, 03 Apr 2007 06:30:22 +0000 |
parents | 2eca9ed49469 |
children |
line wrap: on
line source
This file describes how to compile and run gaim with dbus support. Hopefully, most of the steps from point 3 will soon be automated. 1. Make sure you have the latest version (0.34) of the dbus library installed, including glib bindings. http://www.freedesktop.org/Software/dbus 2. Compile gaim ./configure --enable-dbus make make install 3. Configure your dbus instalation for gaim A. Find your dbus session configuration file, usually /etc/dbus-1/session.conf B. In that file, find the <servicedir> section. This section contains the directory that stores files describing services, usually /usr/share/dbus-1/services C. Copy src/dbus-gaim.service to that directory D. Edit the dbus-gaim.service file you've just copied, and replace the path in the "Exec=" line with the path to your gaim executable. 4. Start Session DBUS if you haven't done it already eval `dbus-launch --session` export DBUS_SESSION_BUS_ADDRESS DBUS_SESSION_BUS_PID These commands will set the two above shell variables. These variables must be set before running any dbus-aware programs. Start gaim as usual. To communicate with it, use "gaim-send". When you execute gaim-send, the dbus system will automatically start a gaim process if one is not running already.