Mercurial > pidgin
view README.dbus @ 12903:2bb4dc533a31
[gaim-migrate @ 15256]
redpen686 posted modified sounds to gaim-devel:
"The tones were sampled at 44.1 KHz (with a range of up to 22.05 KHz),
which is fine, but since the tones are only up to ~3 to 4 KHz, a lot of
space could be saved by downsampling.
I went to 11,025 Hz, since it is already enough for these frequencies,
and it's also the lowest common denominator for soundcards (rather than
8 or 16 KHz, for example).
The 'alert' sound needed a lowpass filter, but only because of the
high-pitched attack, which people won't notice anyway.
All are still 16-bit, and in stereo (except for the 'alert' sound, which
didn't need it), and so should sound virtually identical."
These are significantly smaller files and I didn't notice a difference in
the sound (of course, my speakers suck). They're also louder, which is good.
I'm committing these so people can try them out.
committer: Tailor Script <tailor@pidgin.im>
author | Richard Laager <rlaager@wiktel.com> |
---|---|
date | Tue, 17 Jan 2006 02:49:32 +0000 |
parents | 2eca9ed49469 |
children |
line wrap: on
line source
This file describes how to compile and run gaim with dbus support. Hopefully, most of the steps from point 3 will soon be automated. 1. Make sure you have the latest version (0.34) of the dbus library installed, including glib bindings. http://www.freedesktop.org/Software/dbus 2. Compile gaim ./configure --enable-dbus make make install 3. Configure your dbus instalation for gaim A. Find your dbus session configuration file, usually /etc/dbus-1/session.conf B. In that file, find the <servicedir> section. This section contains the directory that stores files describing services, usually /usr/share/dbus-1/services C. Copy src/dbus-gaim.service to that directory D. Edit the dbus-gaim.service file you've just copied, and replace the path in the "Exec=" line with the path to your gaim executable. 4. Start Session DBUS if you haven't done it already eval `dbus-launch --session` export DBUS_SESSION_BUS_ADDRESS DBUS_SESSION_BUS_PID These commands will set the two above shell variables. These variables must be set before running any dbus-aware programs. Start gaim as usual. To communicate with it, use "gaim-send". When you execute gaim-send, the dbus system will automatically start a gaim process if one is not running already.