Mercurial > pidgin
view README.dbus @ 13686:2d31d61f572c
[gaim-migrate @ 16089]
SF Patch #1470203 from Sadrul
"If someone (using gaim, not sure about any other) on my
buddy-list is away on yahoo, and goes idle, then
there's a status-changed signal emitted saying that the
buddy changed status to "available" -- which is not
correct."
"Also, when you have a status-message, and become idle,
the status-message for that gets lost. This apparently
was caused by my last patch."
committer: Tailor Script <tailor@pidgin.im>
author | Richard Laager <rlaager@wiktel.com> |
---|---|
date | Mon, 24 Apr 2006 20:15:34 +0000 |
parents | 2eca9ed49469 |
children |
line wrap: on
line source
This file describes how to compile and run gaim with dbus support. Hopefully, most of the steps from point 3 will soon be automated. 1. Make sure you have the latest version (0.34) of the dbus library installed, including glib bindings. http://www.freedesktop.org/Software/dbus 2. Compile gaim ./configure --enable-dbus make make install 3. Configure your dbus instalation for gaim A. Find your dbus session configuration file, usually /etc/dbus-1/session.conf B. In that file, find the <servicedir> section. This section contains the directory that stores files describing services, usually /usr/share/dbus-1/services C. Copy src/dbus-gaim.service to that directory D. Edit the dbus-gaim.service file you've just copied, and replace the path in the "Exec=" line with the path to your gaim executable. 4. Start Session DBUS if you haven't done it already eval `dbus-launch --session` export DBUS_SESSION_BUS_ADDRESS DBUS_SESSION_BUS_PID These commands will set the two above shell variables. These variables must be set before running any dbus-aware programs. Start gaim as usual. To communicate with it, use "gaim-send". When you execute gaim-send, the dbus system will automatically start a gaim process if one is not running already.