Mercurial > pidgin
view README.dbus @ 13598:41e40b323dc3
[gaim-migrate @ 15984]
Previously our file transfer dialog showed "time elapsed" as the current
time minus the time when the transfer was added to the ft dialog.
When sending a file, the transfer is added when you offer the file to
the remote user, not when the transfer actually starts. This meant the
"time elapsed" was longer than it should have been, which threw off the
transfer rate.
This should fix that.
committer: Tailor Script <tailor@pidgin.im>
author | Mark Doliner <mark@kingant.net> |
---|---|
date | Sun, 09 Apr 2006 17:38:38 +0000 |
parents | 2eca9ed49469 |
children |
line wrap: on
line source
This file describes how to compile and run gaim with dbus support. Hopefully, most of the steps from point 3 will soon be automated. 1. Make sure you have the latest version (0.34) of the dbus library installed, including glib bindings. http://www.freedesktop.org/Software/dbus 2. Compile gaim ./configure --enable-dbus make make install 3. Configure your dbus instalation for gaim A. Find your dbus session configuration file, usually /etc/dbus-1/session.conf B. In that file, find the <servicedir> section. This section contains the directory that stores files describing services, usually /usr/share/dbus-1/services C. Copy src/dbus-gaim.service to that directory D. Edit the dbus-gaim.service file you've just copied, and replace the path in the "Exec=" line with the path to your gaim executable. 4. Start Session DBUS if you haven't done it already eval `dbus-launch --session` export DBUS_SESSION_BUS_ADDRESS DBUS_SESSION_BUS_PID These commands will set the two above shell variables. These variables must be set before running any dbus-aware programs. Start gaim as usual. To communicate with it, use "gaim-send". When you execute gaim-send, the dbus system will automatically start a gaim process if one is not running already.